Installation guide

Page 6
AsantéHub 2072 BNC Module Installation Guide
The Front
Panel
The BNC Module front panel provides the following LEDs and
connectors:
❏ AUI connector
❏ AUI Uplink LEDs
❏ Ten 10Base2 connectors
❏ Link/Receive LEDs
❏ Segment LEDs (1 and 2)
Figure 3 illustrates the BNC Module front panel; Table 1 lists and
defines the BNC module LEDs and connectors.
Figure 3 BNC Module Front Panel
SEG1
LED
UPLINK 0
AUI
PARTITION PARTITION PARTITION PARTITION PARTITION PARTITION PARTITION PARTITION PARTITION PARTITION
LINK/RECEIVE LINK/RECEIVE LINK/RECEIVE LINK/RECEIVE LINK/RECEIVE LINK/RECEIVE LINK/RECEIVE LINK/RECEIVE LINK/RECEIVE LINK/RECEIVE
AH2072H10-BNC
1
SEG1
SEG 0
2345678910
AUI Connector
AUI Uplink
LED
BNC Port
SEG2
LED
Link/Receive LED
Partition LED
Table 1 BNC Module Front Panel Controls and Indictors
Name Function
AUI Connector
Recessed mini MAU slot
Serves as the uplinking port to a network backbone.
Functions as a compartment for housing the recessed
mini MAU.
BNC Connectors Ten ports; each can be connected to a network device or
to other hubs for daisy chaining via a MAU.
AUI Uplink LED If active MAU is attached, this LED remains lit, indicat-
ing that the link is enabled.
Partition LEDs Ten LEDs indicating partitioning ports on the module.
Link/Receive LEDs Ten LEDs indicating link connection and traffic passing
over the port.
Segment 1 LED
Segment 2 LED
Remains lit to display which backplane a segment
(Seg1 or Seg2) the module is currently connected to.
Neither segment LEDs light if module is not connected
to any of the backplanes, however, the module still
functions as an active repeater.