Installation guide

Questions and Answers to common problems
Q
A
Q
A
Q
A
Q
A
When I turn on my PowerBook using the EN/SC adapter,
an error message appears and the network connection
reverts to LocalTalk. What can I do?
Select Network from the Control Panels and reselect
EtherTalk. Network connections are sometimes broken
when the PowerBook is in Sleep Mode or turned off.
Remove
any old Ethernet drivers by re-running the old
driver's Installer and holding down the option key and
click on Installer's Customize option.
Reinstall the drivers from Asante EtherTalk 5.1 or later,
using the EN/SC driver Customize option. If the problem
persists, call Technical support.
I am trying to run the Asante Troubleshooter with an EN/SC PB
adapter attached. Why is my system locking up?
Make sure the virtual memory is turned off on the Macin-
tosh. Restart
without extensions loaded.
I
connected all the cables and started up my computer but
it does not boot. Why?
There may be a duplicate SCSI address on the network. Make
sure that each SCSI device has a unique SCSI address between
o and 6 and that you have proper SCSI termination.
Why can't I see the EtherTalk icon at start-up and connect
to another device on the network?
Did
the EN/SC extension load at start-up? Did you hold
down the Shift key at start-up? If not, re-install the software
using the Asante EtherTalk installer disk. The EN/SC must
be the first extension to load.
Troubleshooting
4-3