Installation guide

( TEST
)
[ STOP
1
(
HELP
)
[
QUIT
)
SLOT
01: Dnl8lE
A30nte
~ti
TroubleShooter
o Memory Buffer Test
[
REPEAT)
o Network Interface Controller Test
o Loopback Test
o Ping-Pong Test
181 Bandwidth utilization
Collecting Ethernet packets. Type any key to stop.
Good packets: rece i ved :
Total bytes received .
Humber of reset byte count:
CRC Error :
Frame
AI ignment Error
FIFO Overrun Error
Frames Lost Error
Rx Bu f fer Overwr i te Error :
Sample time (secs) :
Bandwidth Uti I ization :
58
6394
o
o
o
o
o
o
15
o 1I
Figure 3-3 Bandwidth Utilization
When you run the Bandwidth Utilization Test it takes a "snap shot"
of the network. This test can be used in conjunction with other net-
work analysis tools to identify network problems. Certain network
criteria is tested and displayed in the window. A brief description of
the criteria is presented in the following list.
• Good packets received
Total good packets (error-free) received by the Asante EN/SC
adapter from the network. This allows you to evaluate the
activity on the network. The activity level can be used as a
benchmark to determine changes in network performance.
• Total bytes received
Total bytes received by the Asante EN/SC adapter from the
network. Good Packets received display total packets not
the size of each packet. Total bytes received is more spe-
cific
because it gives the actual byte count.
Number of reset byte count
This number increments by (1) after every 10
9
byte
received by Asante EN/SC adapter from the network.
TroubleShooter Diagnostic Software
3-7