- Asante Technologies, Inc user manual Ethernet Switch IC36240 Series

To exit global configuration command mode and return to privileged EXEC mode, use one of the following
commands:
Command Purpose
exit
end
Ctrl-Z
Exits global configuration mode and returns to privileged EXEC mode.
To list the commands available in global configuration mode, enter a question mark (?) at the prompt, as shown in the
following example. Enter a question mark (?) after a specific command to see all the options for that command.
Switch# configure
Switch(config)# ?
access-list Add an access list entry
arp Set static arp entry
banner Define a login banner
boot Modify system boot parameters
clock Manage the system clock
define Create a definition
dot1x IEEE 802.1x configuration
duplicate-ip Duplicate IP Address detection Global Commands
enable Modify enable password parameters
end End current mode and change to enable mode
exit Exit current mode and down to previous mode
help Description of the interactive help system
hostname Set system's network name
interface Select an interface to configure
ip Global IP configuration subcommands
lacp Configure LACP
line Configure a terminal line
logging Message Logging global configuration commands
mac Add a mac access list entry
mac-address-table MAC Address Table global configuration command
monitor Traffic Monitoring Global configuration commands
no Negate a command or set its defaults
priority-list Priority List global configuration commands
quit Exit current mode and down to previous mode
service Modify use of network based services
show Show running system information
snmp-server Modify SNMP parameters
sntp Modify SNTP parameters
spanning-tree Spanning Tree Protocol global command
tos-list Tos List global configuration commands
username To establish a username-based authentication system
vlan VLAN global configuration command
write Write running configuration to memory, network, or terminal
From global configuration mode, you can access three additional configuration modes: Use the interface, spanning-
tree, and vlan commands to access their respective configuration modes.
25 Asante IntraCore IC36240 Setup Guide