Repair Manual, Parts List, Diagrams and Assembling Charts

23102 Page 34
DEFECTS: CAUSES:
SERVICING:
NOTE:
Push down the AM switch
lever and check with a
circuit tester if the battery
contact piece B (01018) is
electrically connected with the
print wiring base (10004-).
e. Even when the AM switch e. Adjust the position of (05016)
lever (01069) is pushed down, with tweezers so that it does
the switch A (05016) remains not touch (05018) when the
in contact with the switch B AM switch lever (01069) is
(05018). pushed down. (in a state that
the switch actuator pin(02095)
NOTE: is moved to
the
right as shown
Check in the same way as in in Figure 1. d.
the foregoing 1.d.
2. Broken or disconnected wire or 2. Replace the ammeter.
Short-circuit inside the ammeter.
NOTE:
NOTE: 1) No interchangeability
Unsolder the soldered point of between the ammeter for
the lead wire of the ammeter Product No. 231 and that
on the print wiring base (1004) for Product No. 23102.
to remove the-wire, and check
with a circuit tester if the 2) If the ammeter is in good
ammeter is in good working order when tested with a
order. circuit tester, it must
indicate approx. 3kΩ.