Repair Manual, Parts List, Diagrams and Assembling Charts

23102 Page 10
Slightly rotate the top main gear retainer screw (03044) clockwise with a screwdriver, and ease the force of
your driver-holding hand, at which determine if the bottom main gear (03026) will revert itself steadily, say,
by 2 or 3 cogs of the gear.
As explained in paragraph……of the Disassembly section, when the wind-up shaft parts are replaced, adjust
the torque of the spool with (W 17) washers by carefully comparing it with the torque of the spooi of another
Spotrnatic in good working order.
e. ASSEMBLY AND ADJUSTMENT OF INTERMEDIATE GEAR PARTS
Note Lubricate the intermediate gear shaft (05048) very slightly. If oiled excessively, it will invariably result
in irregularity of the shutter speed. Do not lubricate the top intermediate gear (05033) or the bottom
intermediate gear (05034).
Set the shutter curtain in the wound condition with the special tool 231 K-E 15-A. Turn the top main gear
retainer screw (03044) with a screwdriver to position the teeth of the counter actuator dial (03021) as
illustrated in Diagram 10.
Paying attention not to move the wind-up shaft (03042), assemble the bottom intermediate gear (05034) with
(05048) so that the square hole of (05034) will fit the square groove of the intermediate gear shaft (05048),
and the top 3rd gear (C 25) will engage with (05034) and the top main gear (C 26).
Turn the non-return arm (03008) clockwise with the tip of tweezers, and check if (03008) is in contact with the
side of the bottom part of the bottom intermediate gear (05034).