Repair Manual, Parts List, Diagrams and Assembling Charts

23102 Page 9
d. ASSEMBLY AND ADJUSTMENT OF FILM TRANSPORT MECHANISM
First, put the sprocket collar (03058) and (W 30) onto the sprocket (03057-2) using grease G-1, the former at
its top and the latter at its bottom. Install them in the body proper (01001). Then set (LW 13), (W 28), clutch
ring (03095), speed dial knob retainer screw (05100) and sprocket spring (03089) onto the sprocket shaft
(03054-2). Insert this assembled parts into the aforementioned sprocket (03057-2) through the bottom of the
body proper (01001), and fix the bottom mech. plate (03002) onto (01001).
Fasten the sprocket (03057-2) from its side with the sprocket retainer screw (03055-2), assuring that the tip of
the screw go right into the long slot of (03095).
While pushing the sprocket shaft (03054-2) from its bottom, rotate (03057-2) with your fingertip to check if it
functions smoothly. Then push (03054-2) again from its bottom and rotate (03057-2) several times with your
finger, after which lift your finger to check if (03054-2) remains recessed by dint of the functioning of the
clutch but satisfactorily reverts itself to its original position once (03057-2) is again rotated.
Assemble the spool (03009), top take-up spool brim (03010) and bottom take-up spool brim (03011) in one
body, and install it in the spool chamber of the body proper (01001). Drop the wind-up shaft (03042) into the
body proper (01001) through its upper hole and affix the wind-up shaft bearing (03043) to the body proper
(01001) with small screw (SM 1.7 x 3.5) through the top mec. plate (03001).
With the special tool 231 K-C 27-A, screw the bottom main gear (03027) clockwise onto the wind-up shaft
(03042) through the bottom of (01001). When doing so, see to it that the wind-up shaft (03042) is retained
intact with the special tool 231 K-C 27-A so that it will not rotate.
While holding (03027) steadily with the
special tool 231 K-C 26-A, fasten the top
main gear (03026), turning it clockwise
with the special tool 231 K-C 23-A.
Note: Do not under any circumstances
turn and fasten the bottom main
gear (03027).