User manual

Web Panel User Manual Rev. 2
7.1 Prerequisites
Before you start configuring button configurations for web panels in the System
Configurator, there are some tasks that should be done.
For further information about using the System Configurator, please see the “System
Configurator User Manual”.
7.1.1 Enabling Web Panel configuration
If you are currently using the System Configurator you will need to download the latest
version from the Network Electronics ASA web page or install the version received on a CD
when ordering the product. This only applies for System Configurator version 3.2.7 or older
(Web Panels are supported by System Configurator 3.3.0 and later versions).
In the System Configurator, open “Help”->”Product Key Manager” to verify that you have a
valid System Configurator with the Web Panel feature enabled.
If not, add a new product key with the Web Panel feature by clicking the “Add new” button.
You will have received such a product key when receiving the Web Panel Server product.
7.1.2 Router System
Use the System Configurator to detect your system controllers (SYSCON or ETHCON) and
configure them with correct levels and mnemonics. Redundancy and interconnection should
also be configured.
7.1.3 Virtual Router Mapping
The Web Panels are using the virtual router mapping when controlling routers. Create a
virtual router mapping matching your system. Configure names, icons and categories in the
virtual router mapping.
Note!
Web Panels require a virtual router. It is not possible to configure a web panel
without sources or destinations from a virtual router, except for salvos.
7.1.4 Salvos
If you plan to use salvos on the Web Panels the salvos must be created prior to creating the
Web Panel button configurations.
network-electronics.com | 25