RESET BUTTON A RESET button is located on the front of the chassis.
APPLICATION NOTES This note will discuss DC Power sources and how they relate to 12 volt products. WIRING DIAGRAM (Figure 2) CONNECTIONS General Specifications Our general specification for the voltage range of operation is 10 to 16 volts DC . Voltage The voltage of a fully charged battery ( engine not running ) is approximately 12.5 VDC. Once a load (items being powered represent the "load" ) is applied , the voltage will drop. How much the voltage is reduced will depend on the following: 1.
TROUBLESHOOTING CHART AM/FM RADIOS Symptom No Power Power indicated; no audio output or very distorted sound Only one channel (right or left side) Cause No 12VDC Possible Solution Check circuit fuse at source Check in-line fuse on power lead Power lead disconnected Ground connection disconnected No 12VDC to memory lead(electronically tuned units only) Circuit fuse at source In-line memory lead fuse Speaker Output shorted Check continuity of speaker leads to ground Speaker out cross channeled Check
