Technical information

Norman Wells Fire Department
SVI Emergency Vehicles
NORNWLR-0002 11/02/12
Page 39 of 63
PLASTIC FLOOR AND SHELF TILE
All compartment floors, shelves, and trays shall be covered with Dri-Dek plastic interlocking grating.
• The plastic floor tile shall be black.
• The plastic edge trim shall be black.
SIDE BODY PROTECTION - RUB RAIL
OnScene Solutions rub rails shall be provided below the compartment door openings on both the streetside and
curbside.
The rub rail shall be fabricated from 6063 extruded aluminum, measuring approximately 2-3/4" high x 1-3/8" thick
with tapered aluminum end caps. The rub rail shall be bolted to the body using stainless steel bolts and 1-1/2"
diameter x 5/8" thick rubber mount isolators to prevent damage to the body.
The rails shall incorporate LED clearance marker lighting recessed into the rail fascia to avoid damage to the light
in case of impact. The rub rail shall have an accessory mounting track integrated into the backside of the rail to
allow mounting of accessories such as ground lighting.
FRONT GRAVEL GUARDS
Gravel guards shall be fabricated of 18 gauge brushed stainless steel. They will measure 12" high. The guards
will start at the edge of the door track or door hinge and will wrap around the corner of the end panel and cover
approximately 12" of the front.
REAR PROTECTION PANELS
Body protection panels shall be provided, fabricated from .100 thick aluminum tread plate. To protect areas
subject to intensive wear, scuffing or abuse, the protection panels shall be installed below the rear compartment
door opening.
REAR BODY HANDRAILS
There shall be two (2) vertical handrails on the rear of the body. Handrails shall be NFPA compliant 1-1/4" knurled
304 stainless steel with welded end stanchions.
FOLDING STEP(S)
There shall be two (2) NFPA approved folding step(s) furnished and installed. Each step shall be cast aluminum
with heavy duty stainless steel spring and textured step surface.