Technical information

Norman Wells Fire Department
SVI Emergency Vehicles
NORNWLR-0002 11/02/12
Page 31 of 63
STREETSIDE COMPARTMENT - ABOVE REAR WHEELS (S2)
The interior useable compartment width shall be approximately 45.0" wide x 23" deep.
The compartment door opening shall be approximately 38.0" wide.
This compartment shall have a ROM roll-up door.
• The roll-up door slats and the door trim components shall be painted to match the single tone exterior
color.
• The door shall be equipped with a CPI harsh environment mechanical type door ajar switch located inside
compartment interior lower door track.
• There shall be NO keyed lock on this roll-up compartment door.
A compartment threshold protection plate shall be installed on the bottom edge of the compartment door opening.
The threshold protection shall be fabricated from an aluminum extrusion with an anodized exterior finish.
COMPARTMENT LAYOUT
• There shall be vertically mounted aluminum shelf-trac for specified component installation.
• There shall be one (1) SCBA cylinder storage module for 8" OD (maximum) SCBA bottles. The maximum
length of the SCBA cylinder shall be 24.75". The module shall have an exterior shell fabricated from 1/8"
(.125) 3003H-14 aluminum alloy sheet. The module shall have a 2" slope, front to back to prevent cylinders
from sliding out. The SCBA cylinder storage tubing shall be fabricated from PVC pipe to prevent damage or
abrasion to cylinders. In addition there shall be rubber matting provided in the base of each storage tube for
bottle protection and to prevent slipping.
− The SCBA cylinder module shall be capable of storing twelve (12) SCBA cylinders up to 7.5" diameter.
• Two (2) OnScene 36" Access LED compartment lights, vertically mounted.