Specifications

SVI Trucks

Freightliner 4-Door Demo

SVI #917 01/05/15

Rear body tail lights shall be vertically mounted and located per Federal Motor Vehicle Safety Standards, FMVSS

and Canadian Motor Vehicle Safety Standards CMVSS. The following lights shall be furnished;

 Two (2) Whelen amber LED 600 Series 60A00TAR turn signal lights

 Two (2) Whelen red LED 600 Series 60BTT stop/tail lights

 Two (2) Whelen Halogen 600 Series 60J000CR back-up lights with clear lens

Each of the lights above shall be mounted in a 6EFLANGE, chrome finish bezel.

MIDSHIP MARKER/TURN SIGNAL

Two (2) Whelen model T0A00MAR 2" round amber LED midship body clearance marker/turn signal lights shall be

provided and installed, one (1) light on each side of the body, in forward wheel well of rear axle. Midship

marker/turn lights shall be wired to the headlight circuit of the chassis.

MARKER LIGHTS

The body shall be equipped with all necessary clearance lights and reflectors in accordance with Federal Motor

Vehicle Safety Standards (FMVSS) and Canadian Motor Vehicle Safety Standards (CMVSS) regulations. All body

clearance lights shall be Truck-Lite Model 18 LED to reduce the need for maintenance and lower the amp draw.

Clearance lights shall be wired to the headlight circuit of the chassis.

CAB STEP LIGHTS / GROUND LIGHTS

There shall be two (2) OnScene 8" Access LED light(s) installed on the vehicle capable of providing illumination at

a minimum level of 2 fc (20 lx) on ground areas within 30 in. (800 mm) of the edge of the vehicle in areas

designed for personnel to climb onto or descend from the vehicle to the ground level.

Lighting designed to provide illumination on areas under the driver and crew riding area exits shall be switchable

but activated automatically when the exit doors are opened.

LICENSE PLATE LIGHT

One (1) Arrow #437 chrome plated LED license plate light shall be installed on the rear of the body. License plate

light shall be wired to the headlight circuit of chassis. A fastener system shall be provided for license plate

installation.

ELECTRONIC SIREN

One (1) Whelen model 295SLSA1 electronic siren control with selectable 100 or 200 watt output, hands-free

operation, user selectable siren tones, park kill, and standard hard wired microphone shall be provided and

installed in cab within easy reach of Driver. Siren power shall be wired through the master warning light switch.

SIREN SPEAKER

One (1) Whelen model SA122FMP siren speaker shall be provided, recessed in the front bumper.

The siren speaker shall be located behind the center of front bumper.

SCENE LIGHTS

The scene lighting shall be provided with specified upper side and/or rear warning lights.