Specifications
SVI Trucks
Freightliner 4-Door Demo
SVI #917 01/05/15
52
CURBSIDE COMPARTMENT - REAR (C4)
The interior useable compartment width shall be approximately 49.0" wide.
The compartment door opening shall be approximately 42.0" wide.
This compartment shall have a ROM roll-up door.
The roll-up door shall have an unpainted satin aluminum finish on the door slats and the door trim
components.
The door shall be equipped with a CPI harsh environment mechanical type door ajar switch located inside
compartment interior lower door track.
A keyed cylinder lock shall be provided in the bottom portion of the roll-up door.
One (1) nylon strap shall be provided to assist in closing the door. The strap shall be fastened to the left side
of the lower inside door sill. The strap shall extend from the left side of the lower inside door sill to a footman
loop attached to the center of the left side of the door frame.
A compartment threshold protection plate shall be installed on the bottom edge of the compartment door
opening. The threshold protection shall be fabricated from an aluminum extrusion with an anodized exterior
finish.
COMPARTMENT LAYOUT
There shall be vertically mounted aluminum Shelf-Trac for specified component installation. Shelf-Trac
extrusion shall have side extruded channels for use in mounting or securing special ancillary items, without
need for drilling into body.
There shall be one (1) adjustable shelf/shelves approximately 24" deep. Each shelf shall be fabricated from
3/16" 3003 aluminum sheet with a 2" vertical flange along the front and rear edge.
There shall be two (2) slide-out smooth aluminum vertical tool board(s) approximately 24" deep. Each tool
board(s) vertical exterior edge shall have a double 90 degree formed edge to provide an easy grip handle.
The top and bottom of tool board(s) shall be provided with Accuride 9300 series slide tracks. Each board shall
be rated for a maximum 200 lbs. evenly distributed load. Each tool board shall utilize a pneumatic cylinder to
hold the tool board in both the opened and closed positions.
The vertical tool board material shall be 3/16" (.188) 3003H-14 aluminum alloy sheet.
Each tool board shall be horizontally adjustable; mounted on aluminum shelf trac on compartment floor.
The floor of the compartment above the frame rails shall cover the area directly above the frame rails ONLY
(non-extended floor).
One (1) OnScene 64" Access LED compartment light, vertically mounted.
Two (2) 3-1/2" x 3-1/2" black plastic louvered vents shall be provided in the lower compartment.