Specifications
SVI Trucks
Freightliner 4-Door Demo
SVI #917 01/05/15
50
CURBSIDE COMPARTMENT - AHEAD OF REAR WHEEL (C2)
The interior useable compartment width shall be approximately 41.0" wide.
The compartment door opening shall be approximately 34.0" wide.
This compartment shall have a ROM roll-up door.
The roll-up door shall have an unpainted satin aluminum finish on the door slats and the door trim
components.
The door shall be equipped with a CPI harsh environment mechanical type door ajar switch located inside
compartment interior lower door track.
A keyed cylinder lock shall be provided in the bottom portion of the roll-up door.
One (1) nylon strap shall be provided to assist in closing the door. The strap shall be fastened to the left side
of the lower inside door sill. The strap shall extend from the left side of the lower inside door sill to a footman
loop attached to the center of the left side of the door frame.
A compartment threshold protection plate shall be installed on the bottom edge of the compartment door
opening. The threshold protection shall be fabricated from an aluminum extrusion with an anodized exterior
finish.
COMPARTMENT LAYOUT
There shall be vertically mounted aluminum Shelf-Trac for specified component installation. Shelf-Trac
extrusion shall have side extruded channels for use in mounting or securing special ancillary items, without
need for drilling into body.
There shall be one (1) 400 lbs. slide-out tray(s) approximately 24" deep and as wide as the compartment
layout or door opening permits. The tray top shall be fabricated from 3/16" 3003 aluminum sheet with a 3"
vertical lip and welded corners to form a box type tray surface. The sliding tracks shall extend 100% of the
slide length. The tray assembly shall utilize a pneumatic cylinder mounted on underside to hold the tray in
both the extended and closed positions.
There shall be one (1) OnScene Solutions 83 series aluminum tray base with 70% extension, and rating of
1,000 lbs. Slide-out tray(s) base shall be approximately 94" deep; capable of extending out either side of the
body located above the level of the chassis frame rails. (Specified in opposite side compartment.)
There shall be a transverse storage module which extends from the opposite side of the body (specified in
opposite side compartment).
The floor of the compartment above the frame rails shall be extended to the interior edge of the door. The
floor shall have a 2" vertical lip and a 1" return to increase strength.
One (1) OnScene 64" Access LED compartment light, vertically mounted.
Two (2) 3-1/2" x 3-1/2" black plastic louvered vents shall be provided in the lower compartment.