Specifications
SVI Trucks
Freightliner 4-Door Demo
SVI #917 01/05/15
48
CURBSIDE COMPARTMENT - FRONT (C1)
The interior useable compartment width shall be approximately 41.0" wide.
The compartment door opening shall be approximately 34.0" wide.
This compartment shall have a ROM roll-up door.
The roll-up door shall have an unpainted satin aluminum finish on the door slats and the door trim
components.
The door shall be equipped with a CPI harsh environment mechanical type door ajar switch located inside
compartment interior lower door track.
A keyed cylinder lock shall be provided in the bottom portion of the roll-up door.
One (1) nylon strap shall be provided to assist in closing the door. The strap shall be fastened to the left side
of the lower inside door sill. The strap shall extend from the left side of the lower inside door sill to a footman
loop attached to the center of the left side of the door frame.
A compartment threshold protection plate shall be installed on the bottom edge of the compartment door
opening. The threshold protection shall be fabricated from an aluminum extrusion with an anodized exterior
finish.
COMPARTMENT LAYOUT
There shall be vertically mounted aluminum Shelf-Trac for specified component installation. Shelf-Trac
extrusion shall have side extruded channels for use in mounting or securing special ancillary items, without
need for drilling into body.
There shall be one (1) OnScene Solutions 83 series aluminum tray base with 70% extension, and rating of
1,000 lbs. Slide-out tray(s) base shall be approximately 94" deep; capable of extending out either side of the
body located above the level of the chassis frame rails. (Specified in opposite side compartment.)
There shall be one (1) vertical partition(s) installed on tray dividing the tray into left and right sides. Each
vertical partition shall be horizontally adjustable; mounted on aluminum shelf trac on tray floor.
The floor of the compartment above the frame rails shall be extended to the interior edge of the door. The
floor shall have a 2" vertical lip and a 1" return to increase strength.