Specifications
SVI Trucks
Freightliner 4-Door Demo
SVI #917 01/05/15
47
STREETSIDE COMPARTMENT - REAR (S4)
The interior useable compartment width shall be approximately 49.0" wide.
The compartment door opening shall be approximately 42.0" wide.
This compartment shall have a ROM roll-up door.
The roll-up door shall have an unpainted satin aluminum finish on the door slats and the door trim
components.
The door shall be equipped with a CPI harsh environment mechanical type door ajar switch located inside
compartment interior lower door track.
A keyed cylinder lock shall be provided in the bottom portion of the roll-up door.
One (1) nylon strap shall be provided to assist in closing the door. The strap shall be fastened to the left side
of the lower inside door sill. The strap shall extend from the left side of the lower inside door sill to a footman
loop attached to the center of the left side of the door frame.
A compartment threshold protection plate shall be installed on the bottom edge of the compartment door
opening. The threshold protection shall be fabricated from an aluminum extrusion with an anodized exterior
finish.
COMPARTMENT LAYOUT
There shall be vertically mounted aluminum Shelf-Trac for specified component installation. Shelf-Trac
extrusion shall have side extruded channels for use in mounting or securing special ancillary items, without
need for drilling into body.
There shall be two (2) adjustable shelf/shelves approximately 24" deep. Each shelf shall be fabricated from
3/16" 3003 aluminum sheet with a 2" vertical flange along the front and rear edge.
There shall be one (1) OnScene Solutions 86 series aluminum tray base with 100% extension, and rating of
600 lbs. The tray base shall be 30" wide maximum x 24" deep. Each slide base shall have a cable operated,
spring loaded latch complimented by a red "T" handle (Pull to Release) which shall lock the tray in the closed
and full extension positions. Each tray top shall be fabricated from 3/16" 3003 aluminum sheet with a 3 ½”
vertical lip and welded corners to form a box type tray surface and as wide as the compartment layout or door
opening permits located below the level of the chassis frame rails.
The floor of the compartment above the frame rails shall cover the area directly above the frame rails ONLY
(non-extended floor).
One (1) OnScene 64" Access LED compartment light, vertically mounted.
Two (2) 3-1/2" x 3-1/2" black plastic louvered vents shall be provided in the lower compartment.