Specifications

SVI Trucks

Freightliner 4-Door Demo

SVI #917 01/05/15

STREETSIDE COMPARTMENT - ABOVE REAR WHEELS (S3)

The interior useable compartment width shall be approximately 59.0" wide.

The compartment door opening shall be approximately 52.0" wide.

This compartment shall have a ROM roll-up door.

 The roll-up door shall have an unpainted satin aluminum finish on the door slats and the door trim

components.

 The door shall be equipped with a CPI harsh environment mechanical type door ajar switch located inside

compartment interior lower door track.

 A keyed cylinder lock shall be provided in the bottom portion of the roll-up door.

 One (1) nylon strap shall be provided to assist in closing the door. The strap shall be fastened to the left side

of the lower inside door sill. The strap shall extend from the left side of the lower inside door sill to a footman

loop attached to the center of the left side of the door frame.

 A compartment threshold protection plate shall be installed on the bottom edge of the compartment door

opening. The threshold protection shall be fabricated from an aluminum extrusion with an anodized exterior

finish.

COMPARTMENT LAYOUT

 There shall be vertically mounted aluminum Shelf-Trac for specified component installation. Shelf-Trac

extrusion shall have side extruded channels for use in mounting or securing special ancillary items, without

need for drilling into body.

 There shall be one (1) OnScene Solutions 81 series aluminum tray base with 100% extension, and rating of

1,000 lbs. Slide-out tray(s) base shall be approximately 46" deep and as wide as the compartment layout or

door opening permits located above the level of the chassis frame rails. Each slide base shall have a cable

operated, spring loaded latch complimented by a large hand opening and red pull handle (Pull to Release)

which will lock the tray in the closed and full extension positions. Each tray shall be fabricated from 3/16"

3003 aluminum sheet and shall have welded corners to form a box type tray surface with an internal depth of

approximately 3 ½”.

 3M™ Diamond Grade™ Conspicuity striping shall be provided on the front and side faces of the tray. The

striping shall be 2" wide and red/white in color.

 There shall be one (1) OnScene Solutions 84 series aluminum tray base with 90% extension, and rating of

150 lbs. Slide-out tray(s) base shall be approximately 46" deep and as wide as the compartment layout or

door opening permits. It shall be located above the level of the chassis frame rails and shall be vertically

adjustable in height. Each slide shall have a cable operated, spring loaded latch complimented by a large

hand opening and red pull handle (Pull to Release) which will hold the tray in the closed position. Each tray

shall be fabricated from 3/16" 3003 aluminum sheet and have welded corners to form a box type tray surface

with an internal depth of approximately 3 ½”.

 One (1) OnScene 36" Access LED compartment light, vertically mounted.