Specifications
SVI Trucks
Freightliner 4-Door Demo
SVI #917 01/05/15
44
STREETSIDE COMPARTMENT - AHEAD OF REAR WHEELS (S2)
The interior useable compartment width shall be approximately 41.0" wide.
The compartment door opening shall be approximately 34.0" wide.
This compartment shall have a ROM roll-up door.
The roll-up door shall have an unpainted satin aluminum finish on the door slats and the door trim
components.
The door shall be equipped with a CPI harsh environment mechanical type door ajar switch located inside
compartment interior lower door track.
A keyed cylinder lock shall be provided in the bottom portion of the roll-up door.
One (1) nylon strap shall be provided to assist in closing the door. The strap shall be fastened to the left side
of the lower inside door sill. The strap shall extend from the left side of the lower inside door sill to a footman
loop attached to the center of the left side of the door frame.
A compartment threshold protection plate shall be installed on the bottom edge of the compartment door
opening. The threshold protection shall be fabricated from an aluminum extrusion with an anodized exterior
finish.
COMPARTMENT LAYOUT
There shall be vertically mounted aluminum Shelf-Trac for specified component installation. Shelf-Trac
extrusion shall have side extruded channels for use in mounting or securing special ancillary items, without
need for drilling into body.
There shall be one (1) 400 lbs. slide-out tray(s) approximately 24" deep and as wide as the compartment
layout or door opening permits. The tray top shall be fabricated from 3/16" 3003 aluminum sheet with a 3"
vertical lip and welded corners to form a box type tray surface. The sliding tracks shall extend 100% of the
slide length. The tray assembly shall utilize a pneumatic cylinder mounted on underside to hold the tray in
both the extended and closed positions.
3M™ Diamond Grade™ Conspicuity striping shall be provided on the front face of the tray. The striping
shall be 2" wide and red/white in color.
There shall be one (1) OnScene Solutions 83 series aluminum tray base with 70% extension, and rating of
1,000 lbs. Slide-out tray(s) base shall be approximately 94" deep and as wide as the compartment layout or
door opening permits, capable of extending out either side of the body located above the level of the chassis
frame rails. Each slide base shall have a cable operated, spring loaded latch complimented by a large hand
opening and red pull handle (Pull to Release) which will lock the tray in the closed, 40% extended and 70%
extended positions. Each tray top shall be fabricated from 3/16" 3003 aluminum sheet shall have welded
corners to form a box type tray surface with an internal depth of approximately 3 ½”.