Specifications

ST. PETERSBURG FIRE & RESCUE

AIR / LIGHT APPARATUS

SVI #865 PRODUCTION SPECIFICATION

SVI #865 04/26/13

SHORE POWER INLET

One (1) Kussmaul 120 VAC, 20 amp shore power inlet with weather resistant snap cover shall be provided. The protective

ground from the shoreline inlet shall be bonded to the vehicle frame.

• The outlet cover shall be yellow.

• The shore power plug shall be located near the Driver door area.

ENGINE COMPARTMENT LIGHT

There shall be one (1) light(s) mounted in the engine compartment with integral switch with a light output of at least 20

candlepower (250 lumens). The engine compartment light(s) shall operate only when the master battery switch is turned

"On".

CAB HAZARD WARNING LIGHT

A red flashing or rotating light, located in the driving compartment, shall be illuminated automatically whenever the

vehicles parking brake is not fully engaged and any of the following conditions exist:

• Any passenger or equipment compartment door is not closed.

• Any ladder or equipment rack is not in the stowed position.

• Stabilizer system is not in its stowed position.

• Powered light tower is not stowed.

• Any other device permanently attached to the apparatus is open, extended, or deployed in a manner that is likely to

cause damage to the apparatus if the apparatus is moved.

Compartments and equipment meeting all of the following conditions shall be permitted to be exempt from being wired to

the hazard light:

• The volume is less than or equal to 4 ft3 (0.1 m3).

• The compartment has an opening less than or equal to 144 in.2 (92,900 mm2).

• The open door does not extend sideways beyond the mirrors or up above the top of the fire apparatus.

• All equipment in the compartment is restrained so that nothing can fall out if the door is open while the apparatus is

moving.

• Manually raised pole lights with an extension of less than 5 ft (1.5 m).

The hazard light shall be labeled "DO NOT MOVE APPARATUS WHEN LIGHT IS ON".

An audible alarm shall be provided for the door ajar light.

BACK-UP ALARM

The body manufacturer shall furnish and install one (1) 107 dB(A) electronic back-up alarm. Back-up alarm to actuate

automatically when the transmission gear selector is placed in reverse.