Specifications

ST. PETERSBURG FIRE & RESCUE
AIR / LIGHT APPARATUS
SVI #865 PRODUCTION SPECIFICATION
SVI #865 04/26/13
47
REAR COMPARTMENT - CENTER (RC1)
The rear center compartment shall be closed to both side rear compartments.
The rear center compartment shall start at the bottom of the body and shall be as high as the body permits.
The interior useable compartment width shall be approximately 45.0" wide.
The compartment door opening shall be approximately 38.0" wide.
This compartment shall have a ROM roll-up door.
− The roll-up door slats and the door trim components shall be painted to match the single tone exterior color.
• The door shall be equipped with a CPI harsh environment mechanical type door ajar switch located inside
compartment interior lower door track.
• There shall be NO keyed lock on this roll-up compartment door.
A compartment threshold protection plate shall be installed on the bottom edge of the compartment door opening. The
threshold protection shall be fabricated from an aluminum extrusion with an anodized exterior finish.
COMPARTMENT LAYOUT
• There shall be vertically mounted aluminum shelf-trac for specified component installation.
• There shall be one (1) adjustable shelf/shelves approximately 46" deep. Each shelf shall be fabricated from 3/16"
3003 aluminum sheet with a 2" vertical flange along the front and rear edges.
• There shall be one (1) OnScene Solutions 81 series aluminum tray base with 100% extension, and rating of 1,000 lbs.
Slide-out tray(s) base shall be approximately 46" deep and as wide as the compartment layout or door opening
permits located above the level of the chassis frame rails. Each slide base shall have a cable operated, spring loaded
latch complimented by a large hand opening and red pull handle (Pull to Release) which will lock the tray in the closed
and full extension positions. Each tray shall be fabricated from 3/16" 3003 aluminum sheet and shall have welded
corners to form a box type tray surface with an internal depth of approximately 3 ½”.
• There shall be one (1) module fabricated from 3/16” (.188) 3003H-14 aluminum alloy smooth sheet. The module will
be designed for the following long tools and equipment:
• The list of items to be stored in the transverse module shall be determined at the pre-construction meeting.
• Six (6) St. Petersburg Fire and Rescue supplied sheets of 4’ x 8’ x ¾” sheets of plywood.
SHOP NOTES
Sheets can be cut if necessary. provide dimensions.
− There shall be one (1) OnScene Solutions cargo straps provided to secure the stored equipment.