Technical data

B.10 STATE
The STATE command is used to check the state of the wireless link,
the unit in the link, and the alarm control lines. To specify a radio
unit (local or remote), the CONNECT command must be used in prior
of STATE command using.
STATE [Parameter Name] [Parameters List] [/?]
The STATE command without Parameter Name indicates all values
as shown in Figure B-3:
Note: To activate a newly loaded firmware image and conf
iguration, the unit must be rebooted (see also Section
6.4.3).
Parameter Name Parameters List
TTL1 0/1 – State of TTL_IN1 line
TTL2 0/1 – State of TTL_IN2 line
RSSI
-52 to -116 dBm – Indicates the Receive Signal Strength in
dBm
BER 10
–8
to 10
–3
– Indicates the BER level
AlphaWave Users Manual 3/21/2005
Page B-8
Appendix B
TTL_IN1 = 0
TTL_IN2 = 1
RSSI = -110 dBm
BER < E-5
Figure B-3: STATE Command Display