Technical data

Figure 5-2: Factory Properties
The unit’s factory identification includes:
• Mandatory Entry of Serial Number – Specifies whether
AWare will automatically fill the Serial Number during
downloading configuration into the unit or the operator should
mandatory enter serial number in the “Serial Number” field.
• Serial Number – Indicates the serial number (six/6 bytes) of
the unit given by the manufacture;
• Factory Software Version – The version of software image
loaded in factory. The factory software becomes active if op-
erator updated image is corrupted or failed. The factory soft-
ware cannot be upgraded on the field.
• User Software Version - The version of software image
loaded or upgraded by operator.
5.2 LINK PROPERTIES
The Link settings are split between three tabs: Link General Proper-
ties, Link Protocol Properties, and Link Frequency Properties.
Changing Link Properties of unit’s configuration may cause link inter-
ruption. That is why after choosing Base/Primary unit’s configuration
the operator has limited choices for secondary unit.
Page 5-3
AlphaWave Users Manual 3/21/2005
Chapter 5