Datasheet

Aruba 90 Series Access Points Aruba Data Sheet
• Available channels: Dependent upon congured regulatory domain
• Controller-managed, dependent upon congured
regulatory domain
• Dynamic frequency selection (DFS) optimizes the use of
available RF spectrum
• Supported radio technologies:
- 802.11b: Direct-sequence spread-spectrum (DSSS)
- 802.11a/g/n: Orthogonal frequency division multiplexing (OFDM)
- 802.11n: 2x2 MIMO with two spatial streams
• Supported modulation types:
- 802.11b: BPSK, QPSK, CCK
- 802.11a/g/n: BPSK, QPSK, 16-QAM, 64-QAM
• Transmit power: Congurable in increments of 0.5 dBm
• Maximum transmit power:
- 2.4 GHz: 21 dBm (limited by local regulatory requirements)
- 5 GHz: 21 dBm (limited by local regulatory requirements)
• Maximum ratio combining (MRC) for improved receiver
performance
• Cyclic delay diversity for improved downlink RF performance
• Space-Time Block Coding (STBC) for increased range and
improved reception
• Association rates (Mbps):
- 802.11b: 1, 2, 5.5, 11
- 802.11a/g: 6, 9, 12, 18, 24, 36, 48, 54
- 802.11n: MCS0 to MCS15 (6.5 Mbps to 300 Mbps)
• 802.11n high-throughput (HT) support: HT 20/40
• 802.11n packet aggregation: A-MPDU, A-MSDU
POWER
• 48 volts DC 802.3af power over Ethernet (PoE)
• 12 volts DC for external AC supplied power (adapter
sold separately)
• Maximum power consumption (worst case):
- When powered from PoE: 8 watts
- When powered from DC: 7 watts
ANTENNA
• AP-92 and IAP-92: Two RP-SMA connectors for
external antennas
• AP-93 and IAP-93: Two integrated omni-directional antennas
for 2x2 MIMO with maximum antenna gain of 2.5 dBi in 2.4 GHz
and 5.8 dBi in 5 GHz
INTERFACES
• Network: One 10/100/1000BASE-T Ethernet (RJ-45),
auto-sensing link speed and MDI/MDX
• Power: One DC power connector
• Other: One RJ-45 console interface
MOUNTING
• Included with AP:
- Molded mounting tabs for attaching to 15/16” T-bar
drop-tile ceiling
- Slotted tabs for screw mounting to a wall, ceiling or other
at surface
• Optional AP-90-MNT mounting kit:
- Aruba 90 series AP mount kit contains two ceiling-grid rail
adapters for 9/16” and 15/16” at rails, and one at-surface
wall/ceiling mount bracket.
MECHANICAL
• Dimensions/weight (unit):
- 120 mm x 130 mm x 35 mm (4.7” x 5.1” x 1.4“)
- 255 g (9 oz)
• Dimensions/weight (shipping):
- 180 mm x 155 mm x 45 mm (7.1” x 6.1” x 1.8”)
- 375 g (13.2 oz)
ENVIRONMENTAL
• Operating:
- Temperature: 0° C to 50° C (+32° F to +122° F)
- Humidity: 5% to 95% non-condensing
• Storage and transportation temperature range:
- Temperature: -40° C to +70° C (-40° F to +158° F)
REGULATORY
• FCC/Industry of Canada
• CE Marked
• R&TTE Directive 1995/5/EC
• Low Voltage Directive 72/23/EEC
• EN 300 328
• EN 301 489
• EN 301 893
• UL/IEC/EN 60950
• EN 60601-1-1, EN60601-1-2
For more country-specific regulatory information and approvals,
please see your Aruba representative.
CERTIFICATIONS
• CB Scheme Safety, cTUVus
• UL2043 plenum rating
• Wi-Fi certied 802.11a/b/g/n
WARRANTY
• Limited lifetime warranty
MINIMUM ARUBAOS VERSION
• ArubaOS 5.0.4.2, 6.0.2.1, 6.1.2.0 on an Aruba
Mobility Controller
• Aruba Instant 2.0.0.3 software