Installation guide

Aruba AP-130 Series Access Point | Installation Guide 13

European Union RoHS

Aruba products also comply with the EU Restriction of Hazardous Substances

Directive 2002/95/EC (RoHS). EU RoHS restricts the use of specific hazardous

materials in the manufacture of electrical and electronic equipment. Specifically,

restricted materials under the RoHS Directive are Lead (including Solder used in printed circuit

assemblies), Cadmium, Mercury, Hexavalent Chromium, and Bromine. Some Aruba products are subject to

the exemptions listed in RoHS Directive Annex 7 (Lead in solder used in printed circuit assemblies).

Products and packaging will be marked with the “RoHS” label shown at the left indicating conformance to

this Directive.

China RoHS

Aruba products also comply with China environmental declaration requirements and are

labeled with the “EFUP 10” label shown at the left.

Safety and Regulatory Compliance

Aruba Networks provides a multi-language document that contains country-specific restrictions and

additional safety and regulatory information for all Aruba access points. This document can be viewed or

downloaded from the following location: www.arubanetworks.com/safety_addendum

FCC Class B Part 15

This device complies with Part 15 of the Federal Communications Commission (FCC) Rules. Operation is

subject to the following two conditions:

 This device may not cause harmful interference.

 This device must accept any interference received, including interference that may cause undesired

operation.

Changes or modifications to this unit not expressly approved by the party responsible for compliance could void

the user’s authority to operate this equipment.