Specifications

 Occasionally the SNMP community does not appear in the WebUI until the page
is refreshed. (
7867)
 On the WebUI, navigating to AP >Status > Client may produce an error. (
8285)
 Occasionally, when all the parameters are configured in the LDAP server page of
the WebUI, only some of the configured parameters are applied. (
8023)
 ESI may report incorrect servers in the datapath when servers were moved
around within a group. (7792)
 Some 2Es may report one of the 2E ports as a user on the local switch. (
7365)
 The Monitoring > Switch > Access Points Status and Profile buttons properly
display AP data only for APs on the first page. If you have more APs than will
display on the first page, AP data does not display properly when you click
Status or Profile on these pages. The APs appear, but when you click Status,
no AP status data appears. When you click Profile, only partial AP profile data
appears.)
For switches supporting less than 100 APs, you can increase the maximum page
size (up to 100, which is the upper limit) to keep all the APs on one page.
Otherwise, be advised that displays on subsequent pages will be incomplete.
 When Offline RF Plan is newly installed on a Windows XP-SP2 machine, the
error message: Can't create XMLHttpRequest object: Automation server can't
create object" may appear. You can ignore this message. (7965)
 802.1x role-based VLAN derivation is not working for xSec clients. (8304)
 Access Multiplexer (800-E and 2400-E) 802.1x users are not able to reconnect if
the disconnect and reconnect intervals are too short (less than ten seconds).
(8238)
 Do not enable stateful and wired 802.1x authentication methods at the same
time. If either one is enabled, make sure the other is disabled (8289)
 The "A" channel in ARM configurations has been observed in one installation to
change channels frequently. It is not clear if this problem is related to the site or
to the version of ArubaOS being run, but this bug has not been observed in the
lab with the current software and further testing is required. (7108)
 When users select a port in the ports page of the WebUI, select trunk port, and
click Apply, the following error message appears:
Configuration Failed: Port Configuration is not Changed :: Interface is a Trunk
port. This message can be ignored as the configuration is changed correctly.
(8520)
Upgrading or Downgrading
If the software upgrade distributed with these release notes is on CD or some other
static media, be sure to go to the Customer Support website to make sure you have
the latest release of ArubaOS.
ArubaOS 2.4.1.0 Part 0500116-01 8
Release Notes June 2005