Specifications

 No SNMP traps are generated when software feature licenses are added,
deleted, or expire. Syslog messages, however do report these events.(7450)
 Sygate SMS does not return MPPE keys when user authentication fails and host
authentication is passed. (7736)
 When Sygate Virtual Desktop check is enabled, the first check will always fails
and the subsequent check will pass. (7501)
 When switches are configured for ESI in bridge mode, and an ARP entry for the
gateway does not exist (for example, during switch boot up or just after a clear
ARP command), the switch will not redirect packets to the destination. To fix this
problem, either enter a static ARP entry for the default gateway or ping the
default gateway to create an ARP entry. (8016)
 When using some legacy Cisco Access Points (for example the Cisco AP 1200),
be aware of the following condition when using PoE:
 The Cisco AP is connected to an Aruba mobility controller.
 Cisco mode is enabled (poe cisco).
 PoE is turned off (no poe).
 PoE is turned back on (poe).
 Cisco mode is re-enabled (poe cisco)
The Cisco AP does not power on. To resolve this condition, enter no poe cisco.
The Cisco AP will now function normally as a PoE device. (8054, 7442)
 The multicast key often fails to install for low performance CPUs like FOMA
N900iL. (8171)
 When deleting large blocks of users, they are removed from the user list as well
as mobile client list but user global list still shows the user entries with a zero IP
address value (7960)
 The Captive Portal Login page is not configurable in the WebUI. (8135)
 No accounting record is sent out after a BOAP user authenticates. (8093)
 A command is needed to find out the encryption/decryption statistics from the
AP. (8072)
 User entries in globalTable do not agree with user entries on the switch. (8264)
 Occasionally, moving a user from HA to FA and back to HA causes the mobile
debug future visitor table to display incorrectly. (7589)
 Changing an AP name in RF plan is only temporary. (7293)
 Some Access Points are displayed twice with status as up for one and down for
the other. (8128).
 LDAP servers with base-dn configured with an empty string report an error in IE.
(8181).
 Incorrect tunnel location is displayed by show user command for mux clients.
(8202)
 Bandwidth for the Aruba 2E is limited and shared in duplex mode. (7397)
 10M half-duplex traffic on enet 0 for the Aruba 2E has low throughput. (7400)
 Unable to place more than 5 phone conversations using wpa2-aes-psk. (8102)
7