Specifications

 After a role-based VLAN is disabled, the 802.1x client will not have connectivity
for a few minutes. (7892)
 Monitoring > Switch Summary may not display the correct total of clients and
switches. The WLAN client summary may be smaller than the total of client
entries because the per-switch display includes additional entries – which are not
shown in the global user list. (7904)
 When you upload a license certificate, fpweb will restart. This is normal.
However, the restart event is incorrectly logged as an fpweb crash. You can
ignore this log message. (7940)
 After restoring a configuration, verify that your logging levels are set properly as
they may not be restored. (7542)
 If you have licensed features on a Supervisor Card and need to replace that
card, be sure to restore the configuration from backup on the new card to restore
your license information. For more information, refer to the Managing Software
Feature Licenses document that ships with your switch.
 Using A60/61 APs with Cisco 3550 PoE switches requires the Cisco switches to
running IOS 12.1 (19) or later. Aruba recommends that you also make the
following configuration settings on the Cisco 3550 (INLINE POWER) port:
 power inline delay shutdown 15 initial 25
 (config-if) spanning-tree portfast
 The 800-E and the 2400-E Gigethernet ports only support 1000Base-T rates.
 In this release, if the logging level of authmgr (formerly known as arubaauth) is
set to a non-default level, when the Switch is upgraded to 2.4, the logging level is
changed to the default level of Informational. (7959)
 Sygate SODA users should note that upload file names cannot contain spaces.
 Wired clients appear on All WLAN Clients pages in the WebUI .(7968)
 Funk-Odyssey clients may experience delays in getting authenticated when
using WPA encryption and server derivation roles where the VLAN of the client is
set by matching a particular attribute. Aruba recommends that these users set
the WPA Key Timeout and WPA Retry Count to 5.
 Due to current limitations in the Funk-Odyssey client software, clients cannot
associate via a third-party APs or Bridges if xSec encryption is selected. (7684)
 xSec cannot be enabled on uplink trunk ports doing dot1q tagging. (7704)
 Some client NICs (for example, Dlink, 3Com) may experience problems sending
frames when the MTU size exceeds 1408 bytes (7963)
 The message: “Please reload the switch for the new service key to take effect”
continues to display even after an existing temporary key is replaced with
another temporary or permanent key. A reboot is not required if the associated
feature is already enabled (as shown by the show keys CLI command or on the
WebUI license management page). (7214)
 The message: “Reboot Cause: License Expired” displays with the show
switchinfo CLI command output, but does not specify which of the licenses has
expired and caused a scheduled system reboot. (7215)
ArubaOS 2.4.1.0 Part 0500116-01 6
Release Notes June 2005