Specifications

(aruba) # show image version
----------------------------------
Partition : 0:0 (/dev/hda1) **Default boot**
Software Version : 2.4.1.0
Build number : 10682
Built on : Mon Jun 27 05:52:19 PDT 2005
----------------------------------
Partition : 0:1 (/dev/hda2)
/dev/hda2: Image not present
----------------------------------
Partition : 1:0 (/dev/hdc1)
Not plugged in.
----------------------------------
Partition : 1:1 (/dev/hdc2)
Not plugged in.
It is recommended to load the new image into the backup partition. In the
above example, partition 0 contains the active image. Partition 1 is empty
(image not present) and can be used for loading the new software.
Use the copy command to load the new image into the Aruba Mobility
Controller:
# copy tftp: <server address> <image filename> system:
partition {0|1}
Note— When using the copy command to load a software image, the specified
partition automatically becomes active the next time the switch is
rebooted. There is no need manually select the partition.
Verify that the new image is loaded:
# show image version
Information about the newly loaded software image should be displayed for
the appropriate partition.
13