User guide

Aruba Networks Security Target
Page 5 of 67
1 Introduction
1.1 Overview
1 The Aruba Networks Mobility Controller is a network device that serves as a gateway
between wired and wireless networks and provides command-and-control over
Access Points (APs) within an Aruba dependant wireless network. ArubaOS 6.3 is
the underlying operating system of the Mobility Controller, which is available in
modular chassis or network appliance models:
a) Aruba 7000 and 6000 Series. The Aruba 7240, 7220, 7210 and 6000 with M3
blades are designed for corporate headquarters and large campus
deployments.
b) Aruba 3000 Series. The Aruba 3200, 3400 and 3600 are designed for small,
medium and large enterprises.
c) Aruba 600 Series. The Aruba 620 and 650 are designed for branch offices
and similar deployments.
2 This Security Target (ST) defines the Mobility Controller (7240, 7220, 7210, 6000,
3600, 3400, 3200, 650, 620) with ArubaOS 6.3 Target of Evaluation (TOE) for the
purposes of Common Criteria (CC) evaluation.
3 Whilst the Aruba Networks Mobility Controller offers a wide range of wireless, wired
and remote networking features, the TOE is constrained to the following security
features:
a) Secure communication with remote administrators, authentication servers and
audit servers
b) Secure management including authentication, verifiable updates and auditing
c) Self-verification of integrity and operation
4 For a precise statement of the scope of incorporated security features, refer to
section 2.4. NOTE: The Wireless and Access Point capabilities of these devices
were not tested under this evaluation as those aspects are not within the scope of
the NDPP.
5 Identification
Table 1: Evaluation identifiers
Target of Evaluation
Aruba Networks Mobility Controller (7240, 7220, 7210, 6000, 3600,
3400, 3200, 650, 620) with ArubaOS 6.3
Software Version: 6.3.1.5-FIPS
Security Target
Aruba Networks Mobility Controller (7240, 7220, 7210, 6000, 3600,
3400, 3200, 650, 620) with ArubaOS 6.3 Security Target, v1.12
1.2 Conformance Claims
6 This ST supports the following conformance claims:
a) CC version 3.1 release 3
b) CC Part 2 extended
c) CC Part 3 conformant