Owners manual

91 | Customizing IAP Settings Aruba Instant 6.4.0.2-4.1 | User Guide
Iap_master:1
Adding an IAP to the Network
To add an IAP to the Instant network, assign an IP address. For more information, see Assigning an IP address to
the IAP on page 35.
After an IAP is connected to the network, if the Auto Join Mode feature is enabled, the IAP inherits the configuration
from the Virtual Controller and is listed in the Access Points tab.
If the Auto Join Mode is disabled, perform the following steps to add an IAP to the network:
1. In the Access Points tab, click the New link. The New Access Point window is displayed.
2. In the New Access Point window, enter the MAC address for the new IAP.
3. Click OK.
Removing an IAP from the Network
You can remove an IAP from the network only if the Auto Join Mode feature is disabled. To remove an IAP from the
network:
1. In the Access Points tab, click the IAP to delete. The x icon is displayed against the IAP.
2. Click x to confirm the deletion.
The deleted IAPs cannot join the Instant network anymore and no longer are displayed in the Instant UI. However,
the master IAP details cannot be deleted from the Virtual Controller database.