Owners manual

Aruba Instant 6.4.0.2-4.1 | User Guide Initial Configuration Tasks | 74
Chapter 5
Initial Configuration Tasks
This chapter describes the general configuration tasks to perform when an IAP is set up.
l Basic Configuration Tasks on page 74
l Additional Configuration Tasks on page 78
Basic Configuration Tasks
This section describes the following basic configuration tasks that can be performed in the System>General tab
after an IAP is set up:
l Modifying the IAP Name on page 75
l Updating Location Details of an IAP on page 75
l Configuring Virtual Controller IP Address on page 76
l Configuring Timezone on page 76
l Configuring a Preferred Band on page 75
l Configuring an NTP Server on page 76
l Enabling AppRF Visibility on page 77
The following figure shows an example for the basic configuration settings under the System>General tab:
For information on Mobility Access Switch integration and Dynamic RADIUS proxy configuration, see Mobility
Access Switch Integration on page 356 and Configuring Authentication Servers on page 158Configuring
Authentication Servers on page 158respectively.