Owners manual

(Instant AP)# show uncommitted-config
rf dot11a-radio-profile
no legacy-mode
beacon-interval 200
no dot11h
interference-immunity 3
csa-count 1
no spectrum-monitor
Instant Access Point# commit apply
Using Sequence Sensitive Commands
The Instant CLI does not support positioning or precedence of sequence-sensitive commands. Therefore, Aruba
recommends that you remove the existing configuration before adding or modifying the configuration details for
sequence-sensitive commands. You can either delete an existing profile or remove a specific configuration by using
the no… commands.
The following table lists the sequence-sensitive commands and the corresponding no command to remove the
configuration.
Sequence-Sensitive Command Corresponding no command
opendns <username <password> no opendns
rule <dest> <mask> <match> <protocol> <start-port>
<end-port> {permit |deny | src-nat | dst-nat {<IP-
address> <port>| <port>}}[<option1....option9>]
no rule <dest> <:mask> <match>
<protocol> <start-port> <end-port>
{permit | deny | src-nat | dst-nat}
mgmt-auth-server <auth-profile-name>
no mgmt-auth-server <auth-profile-
name>
set-role <attribute>{{equals| not-equals| starts-
with| ends-with| contains} <operator> <role>| value-
of}
no set-role <attribute>{{equals|
not-equals| starts-with| ends-with|
contains} <operator>| value-of}
no set-role
set-vlan <attribute>{{equals| not-equals| starts-
with| ends-with| contains} <operator> <VLAN-ID>|
value-of}
no set-vlan <attribute>{{equals|
not-equals| starts-with| ends-with|
contains} <operator>| value-of}
no set-vlan
auth-server <name> no auth-server <name>
Table 8: Sequence-Sensitive Commands
Aruba Instant 6.4.0.2-4.1 | User Guide Setting up an IAP | 43