Owners manual

378 | IAP-VPN Deployment Scenarios Aruba Instant 6.4.0.2-4.1 | User Guide
Configuration Steps CLI Commands UI Procedure
and access rules, and
enable authentication
survivability.
(ap)(wired-port-profile "wired-port")# switchport-
mode access
(ap)(wired-port-profile "wired-port")# allowed-vlan
all
(ap)(wired-port-profile "wired-port")# native-vlan
20
(ap)(wired-port-profile "wired-port")# no shutdown
(ap)(wired-port-profile "wired-port")# access-rule-
name wired-port
(ap)(wired-port-profile "wired-port")# type employee
(ap)(wired-port-profile "wired-port")# auth-server
server1
(ap)(wired-port-profile "wired-port")# auth-server
server2
(ap)(wired-port-profile "wired-port")# dot1x
(ap)(wired-port-profile "wired-port")# exit
(ap)(config)# enet1-port-profile wired-port
Configure a wireless SSID to operate in centralized L2 mode and
associate VLAN 20 to the WLAN SSID profile.
(ap)(config) # wlan ssid-profile wireless-ssid
(ap)(SSID Profile "wireless-ssid")# enable
(ap)(SSID Profile "wireless-ssid")# type employee
(ap)(SSID Profile "wireless-ssid")# essid wireless-
ssid
(ap)(SSID Profile "wireless-ssid")# opmode wpa2-aes
(ap)(SSID Profile "wireless-ssid")# vlan 20
(ap)(SSID Profile "wireless-ssid")# auth-server
server1
(ap)(SSID Profile "wireless-ssid")# auth-server
server2
(ap)(SSID Profile "wireless-ssid")# auth-
survivability
and Wireless
Network
Profiles
7. Create access rule for
wired and wireless
authentication.
For wired profile:
(ap)(config)# wlan access-rule wired-port
(ap)(Access Rule "wired-port")# rule any any match
any any any
permit
For WLAN SSID employee roles:
(ap)(config)# wlan access-rule wireless-ssid
(ap)(Access Rule "wireless-ssid")# rule any any match any any any
permit
See
Configuring
AccessRules
for Network
Services
NOTE: Ensure that you execute the commit apply command in the Instant CLI before saving the configuration and
propagating changes across the IAP cluster.
Table 75: IAP Configuration for Scenario
AP Connected Switch Configuration
Client VLANs defined in this example must be opened on the upstream switches in multiple AP deployments, as
client traffic from slave to master is tagged with the client VLAN.
Datacenter Configuration
For information on controller configuration, see Configuring a Controller for IAP-VPN Operations on page 228. The
following GRE configuration is required on the controller:
(host)(config)# interface tunnel <Number>