Owners manual

l Downlink load— Indicates the percentage of the WAN downlink currently utilized. The default value of 0
indicates that the downlink speed is unknown or unspecified.
l Downlink speed —Indicates the WAN downlink speed in Kbps.
l Uplink load—Indicates the percentage of the WAN uplink currently utilized. The default value of 0 indicates that
the downlink speed is unknown or unspecified.
l Uplink speed—Indicates the WAN uplink speed in Kbps.
l Load duration—Indicates the duration in seconds during which the downlink utilization is measured.
l Symmetric links—Indicates if the uplink and downlink have the same speed.
l WAN Link Status— Indicates if the WAN is down (link-down), up (link-up), or in test state (link-under-test).
Creating a Hotspot Profile
To create a hotspot profile:
(Instant AP)(config)# hotspot hs-profile <name>
(Instant AP)(Hotspot2.0 <name>)# asra
(Instant AP)(Hotspot2.0 <name>)# access-network-type <type>
(Instant AP)(Hotspot2.0 <name>)# addtl-roam-cons-ois <roam-consortium-OIs>
(Instant AP)(Hotspot2.0 <name>)# comeback-mode
(Instant AP)(Hotspot2.0 <name>)# gas-comeback <delay-interval>
(Instant AP)(Hotspot2.0 <name>)# group-frame-block
(Instant AP)(Hotspot2.0 <name>)# hessid <hotspot-essid>
(Instant AP)(Hotspot2.0 <name>)# internet
(Instant AP)(Hotspot2.0 <name>)# p2p-cross-connect
(Instant AP)(Hotspot2.0 <name>)# p2p-dev-mgmt
(Instant AP)(Hotspot2.0 <name>)# pame-bi
(Instant AP)(Hotspot2.0 <name>)# query-response-length-limit <integer>
(Instant AP)(Hotspot2.0 <name>)# roam-cons-len-1 <integer>
(Instant AP)(Hotspot2.0 <name>)# roam-cons-len-2 <integer>
(Instant AP)(Hotspot2.0 <name>)# roam-cons-len-3 <integer>
(Instant AP)(Hotspot2.0 <name>)# roam-cons-oi-1 <integer>
(Instant AP)(Hotspot2.0 <name>)# roam-cons-oi-2 <integer>
(Instant AP)(Hotspot2.0 <name>)# roam-cons-oi-3 <integer>
(Instant AP)(Hotspot2.0 <name>)# venue-group <group>
(Instant AP)(Hotspot2.0 <name>)# venue-type <type>
(Instant AP)(Hotspot2.0 <name>)# enable
(Instant AP)(Hotspot2.0 <name>)# end
(Instant AP)#commit apply
The hotspot profile configuration parameters are described in the following table:
Aruba Instant 6.4.0.2-4.1 | User Guide Hotspot Profiles | 350