Owners manual

Converting an IAP using CLI
To convert an IAP
(Instant AP)# convert-aos-ap <mode> <controller-IP-address>
Resetting a Remote AP or Campus AP to an IAP
The reset button located on the rear of an IAP can be used to reset the IAP to factory default settings.
To reset an IAP, perform the following steps:
1. Power off the IAP.
2. Press and hold the reset button using a small and narrow object such as a paperclip.
3. Power on the IAP without releasing the reset button. The power LED flashes within 5 seconds indicating that the
reset is completed.
4. Release the reset button. The IAP reboots with the factory default settings.
All APs have a reset button, except IAP-175P/175AC. Contact Aruba support for resetting these IAPs.
Rebooting the IAP
If you encounter any problem with the IAPs, you can reboot all IAPs or a selected IAP in a network using the Instant
UI. To reboot an IAP:
1. Click the Maintenance link. The Maintenance window is displayed.
2. Click the Reboot tab.
Figure 124 Rebooting the IAP
Aruba Instant 6.4.0.2-4.1 | User Guide IAP Maintenance | 329