Owners manual

In the Instant UI
To configure Ethernet bridging:
1. In the Access Points tab, click the IAP to modify. The edit link is displayed.
2. Click the edit link. The edit window for modifying IAP details is displayed.
3. Click the Uplink tab.
4. Select Enable from the Eth0 Bridging drop-down list.
5. Click OK.
6. Reboot the IAP.
In the CLI
To configure Ethernet bridging:
Instant Access Point# enet0-bridging
Make the necessary changes to the wired-profile when eth0 is used as the downlink port. For more information, see
the Configuring a Wired Profile on page 112
Aruba Instant 6.4.0.2-4.1 | User Guide Mesh IAP Configuration | 309