Owners manual

n Secs between test packets— The frequency at which ICMP test packets are sent.You can
specify a value within the range of 1—3600 seconds.
n Internet check time— Internet check timeout is the duration for the test packet timeout. You
can specify a value within the range of 0—3600 seconds and the default value is 10 seconds.
c. Click OK.
When Internet failover is enabled, the IAP ignores the VPN status, although uplink switching based on VPN status
is enabled.
In the CLI
To enable uplink switching based on VPN status:
(Instant AP)(config)# uplink
(Instant AP)(uplink)# failover-vpn-timeout <seconds>
(Instant AP)(uplink)# end
(Instant AP)# commit apply
To enable uplink switching based on Internet availability:
(Instant AP)(config)# uplink
(Instant AP)(uplink)# failover-internet
(Instant AP)(uplink)# failover-internet-pkt-lost-cnt <count>
(Instant AP)(uplink)# failover-internet-pkt-send-freq <frequency>
(Instant AP)(uplink)# end
(Instant AP)# commit apply
Viewing Uplink Status and Configuration
To view the uplink status and configuration in the CLI:
Instant Access Point# show uplink status
Uplink preemption :enable
Uplink enforce :none
Ethernet uplink bond0 :DHCP
Uplink Table
------------
Type State Priority In Use
---- ----- -------- ------
eth0 UP 0 Yes
Wifi-sta LOAD 6 No
3G/4G INIT 7 No
Internet failover :disable
Max allowed test packet loss:10
Secs between test packets :30
VPN failover timeout (secs) :180
ICMP pkt sent :0
ICMP pkt lost :0
Continuous pkt lost :0
VPN down time :0
Instant Access Point# show uplink config
Uplink preemption :enable
Uplink enforce :none
Ethernet uplink bond0 :DHCP
Internet failover :disable
Max allowed test packet loss:10
Secs between test packets :30
VPN failover timeout (secs) :180
Aruba Instant 6.4.0.2-4.1 | User Guide Uplink Configuration | 299