Owners manual

Figure 70 Tunneling— Routing
3. Update the following parameters:
l Destination— Specify the destination network that is reachable through the VPN tunnel. This defines the IP or
subnet that must reach through the IPsec tunnel. Traffic to the IP or subnet defined here will be forwarded
through the IPsec tunnel.
l Netmask— Specify the subnet mask to the destination defined for Destination.
l Gateway— Specify the gateway to which traffic must be routed. This IP address must be the controller IP
address on which the VPN connection is terminated. If you have a primary and backup host, configure two
routes with the same destination and netmask, but ensure that the gateway is the primary controller IP for one
route and the backup controller IP for the second route.
4. Repeat step 3 to create the required number of routing profiles.
5. Click OK.
6. Click Finish.
In the CLI
(Instant AP)(config)# routing-profile
(Instant AP)(Routing-profile)# route <destination> <mask> <gateway>
(Instant AP)(Routing-profile)# end
(Instant AP)# commit apply
Aruba Instant 6.4.0.2-4.1 | User Guide VPN Configuration | 223