Owners manual

(Instant AP)# commit apply
To configure a guest user:
(Instant AP)(config)# user <username> <password> portal
(Instant AP)(config)# end
(Instant AP)# commit apply
Configuring the Read-Only Administrator Credentials
You can assign the read-only privilege to an admin user by using the Instant UI or CLI.
In the Instant UI
1. Click the System link at top right corner of the Instant main window. The System window is displayed.
2. Click the Admin tab. The Admin tab details are displayed.
3. Under View Only:
a. Specify a Username and Password.
b. Retype the password to confirm.
4. Click OK. When the users log in with these credentials, the Instant UI is displayed in the read-only mode.
In the CLI
To configure a user with read-only privilege:
(Instant AP)(config)# mgmt-user <username> [password] read-only
(Instant AP)(config)# end
(Instant AP)# commit apply
Adding Guest Users through the Guest Management Interface
To add guest users through the Guest Management interface:
1. Log in to Instant UI with the guest management interface administrator credentials. The guest management
interface is displayed.
Figure 45 Guest Management Interface
Aruba Instant 6.4.0.2-4.1 | User Guide Authentication and User Management | 147