Owners manual

113 | Wired Profiles Aruba Instant 6.4.0.2-4.1 | User Guide
Figure 38 New Wired Network Window: Wired Settings Window
3. Click the Wired Settings tab and enter the following information:
a. Name— Specify a name for the profile.
b. Primary Usage — Select Employee or Guest.
c. Speed/Duplex — Ensure that appropriate values are selected for Speed/Duplex. Contact your network
administrator if you need to assign speed and duplex parameters.
d. POE — Set POE to Enabled to enable Power over Ethernet.
The E2 port on RAP-3WNP supports Power Sourcing Equipment (PSE) to supply power to any compliant 802.3af
powered (class 0-4) device. RAP-155P supports PSE for 802.3af powered device (class 0-4) on one port (E1 or E2),
or 802.3at powered DC IN (Power Socket) on two ports (E1 and E2).
e. Admin Status — Ensure that an appropriate value is selected. The Admin Status indicates if the port is up or
down.
f. Content Filtering— To ensure that all DNS requests to non-corporate domains on this wired network are sent
to OpenDNS, select Enabled for Content Filtering.
g. Uplink — Select Enabled to configure uplink on this wired profile. If Uplink is set to Enabled and this network
profile is assigned to a specific port, the port will be enabled as Uplink port. For more information on assigning
a wired network profile to a port, see Assigning a Profile to Ethernet Ports on page 117.
h. Spanning Tree—Select the Spanning Tree checkbox to enable Spanning Tree Protocol (STP) on the wired
profile. STP ensures that there are no loops in any bridged Ethernet network and operates on all downlink
ports, regardless of forwarding mode. STP will not operate on the uplink port and is supported only on IAPs
with three or more ports. By default Spanning Tree is disabled on wired profiles.
4. Click Next. The VLAN tab details are displayed.
5. Configure VLAN for the wired profile. For more information, see Configuring VLAN for a Wired Profile on page
114.
In the CLI
To configure wired settings for:
(Instant AP)(config)# wired-port-profile <name>
(Instant AP)(wired ap profile <name>)# type {<employee> |<guest>}
(Instant AP)(wired ap profile <name>)# speed {10 |100 |1000 |auto}
(Instant AP)(wired ap profile <name>)# duplex {half|full|auto}
(Instant AP)(wired ap profile <name>)# no shutdown
(Instant AP)(wired ap profile <name>)# poe