Owners manual

Aruba Instant 6.4.0.2-4.1 | User Guide Wired Profiles | 112
Chapter 9
Wired Profiles
This chapter describes the following procedures:
l Configuring a Wired Profile on page 112
l Assigning a Profile to Ethernet Ports on page 117
l Editing a Wired Profile on page 117
l Deleting a Wired Profile on page 118
l Link Aggregation Control Protocol for IAP-220 Series on page 118
l Understanding Hierarchical Deployment on page 119
Configuring a Wired Profile
The Ethernet ports allow third-party devices such as VoIP phones or printers (which support only wired connections)
to connect to the wireless network. You can also configure an Access Control List (ACL) for additional security on
the Ethernet downlink.
The wired profile configuration for employee network involves the following procedures:
1. Configuring Wired Settings on page 112
2. Configuring VLAN for a Wired Profile on page 114
3. Configuring Security Settings for a Wired Profile on page 115
4. Configuring Access Rules for a Wired Profile on page 116
For information on creating a wired profile for guest network, see Captive Portal for Guest Access
Configuring Wired Settings
You can configure wired settings for a wired profile by using the Instant UI or CLI.
In the Instant UI
1. Click the Wired link under More at the top right corner of the Instant main window. The Wired window is
displayed.
2. Click New under Wired Networks. The New Wired Network window is displayed. The following figure shows
the contents of the Wired Settings tab: