User`s guide

34 Aruba RF Plan Part 0500030-01
v2.0.3 User’s Guide January 2004
Your floor plan with the Don’t Care box should look similar to this:
Click Save.
Create A Don’t Deploy Area
Click the “New” link in the Areas box located below the lower left corner of the floor
plan in the AP Planning window.
Type Lobby in the Name text box in the Area Editor.
Select “Don’t Deploy” from the Type pull-down menu box.
Click the Apply button.
Notice that an yellow box appears near the center of the floor plan.
Use your mouse (or other pointing device) to place the cursor over the box.
Notice that the information you typed in the editor appears in the box. You will see the name
and type of area, as well as the coordinates of the lower left corner and upper right corner of
the box.
N
OTE—The x = 0 and y = 0 coordinates correspond to the lower left corner of the layout
space.
Using your mouse, left-click and drag the box over the Lobby area on the floor plan.
8
1
2
3
4
5
6