User`s guide

The Aruba RF Plan Tool 39

1/22/04 Review Draft—CONFIDENTIAL

Click Save.

Create A Don’t Deploy Area

Click the “New” link in the Areas box located below the lower left corner of the floor

plan in the AP Planning window.

Type Lobby in the Name text box in the Area Editor.

Select “Don’t Deploy” from the Type pull-down menu box.

Click the Apply button.

Notice that an yellow box appears near the center of the floor plan.

Use your mouse (or other pointing device) to place the cursor over the box.

Notice that the information you typed in the editor appears in the box. You will see the

name and type of area, as well as the coordinates of the lower left corner and upper right

corner of the box.

OTE—The x = 0 and y = 0 coordinates correspond to the lower left corner of the

layout space.

Using your mouse, left-click and drag the box over the Lobby area on the floor plan.

Drag one corner of the box to a corresponding corner of the lobby and using one of

the corner handles of the box, stretch it to fit exactly over the lobby area.

Your floor plan with the Don’t Deploy box should look similar to this:

Click Save.

When you are finished defining area in the Floors page, click the AP Planning button

to advance to the next step in the process (AP Plan page).