User`s guide

1/22/04 Review Draft—CONFIDENTIAL
38 Aruba RF Plan Part 0500030-01
v2.0.3 User’s Guide January 2004
Create A Don’t Care Area
Go back to the AP Planning page. Click on AP Plan in the Feature Tree at the left
side of the browser window.
Click the “New” link in the Areas box located below the lower left corner of the floor
plan in the AP Planning window.
This opens the Area Editor.
Type Shipping and Receiving in the Name text box in the Area Editor.
Select “Don’t Care” from the Type pull-down menu box.
Click the Apply button.
Notice that an orange box appears near the center of the floor plan.
Use your mouse (or other pointing device) to place the cursor over the box.
Notice that the information you typed in the editor appears in the box. You will see the
name and type of area, as well as the coordinates of the lower left corner and upper right
corner of the box.
N
OTEThe x = 0 and y = 0 coordinates correspond to the lower left corner of the
layout space.
Using your mouse, left-click and drag the box over the Shipping and Receiving area.
Drag one corner of the box to a corresponding corner of the Shipping and Receiving
area and using one of the corner handles of the box, stretch it to fit exactly over the
Shipping and Receiving area.
Your floor plan with the Don’t Care box should look similar to this:
1
2
3
4
5
6
7
8