User's Manual

OPERATION
OPERATIONOPERATION
Caution !
In cooker models equipped with a surface
burner safety valve, hold the knob pressed
down to the end when igniting for 10
seconds at the “large flame” position to
activate the safety device.
If the ignition device is out of order, either
due to power failure or humid ignition
device, use a match or a lighter to ignite
the gas.
● Keep the button pressed for
approximately 10 second after ignition
to stabilize the flame.
● If you failed to ignite the burner after
15 seconds. Shut the burner off and
wait for at least one minute before the
next attempt.
Selection of the approprite flame
A correctly adjusted burner has a light blue
flame with a clearly visible internal cone.
Selection of flame size depends on the
position of the burner knob which has been
set:
Depending on requirements, flame
size
can be set in a continuous manner.
Caution !
● Button positions between in are
not recommended. In these positions
the flame is not stabilized and may be
extinguished.
● If the flame goes out repeat the
procedure.
● If the burner flame goes out (for
whatever reason), shut the burner off
and wait for at least one minute before
next attempt.
● Before igniting the burners cover them
with appropriate cookware.
Operation of the burner protection
valve
Some models are equipped with an
automatic system that cuts off gas
supply to a burner when the flame has
disappeared.
This system protects the cooker against
gas leakage when the flame on a burner
goes out e.g. in case of spillage.
The user’s intervention is needed to
re-ignite the burner.
14
15
Mechanical timer
(Only for main oven)
When using the oven, you must set
food cooking time.
1.Turn mechanical timer to the time
position you want.
2.Turn function knob to the function
position you want.
3.Turn temperature knob to the
temperature position
you want.
4.After above operation, oven knob
runs normally.
5.When oven works till pre-set time,
timer will have sound which means
the cooking is finished.
If you don’t want the oven work
controlled by the mechanical timer,
you can turn the mechanical timer
to the position.
When selecting any oven function, the
oven will only be switched on after the
temperature has been set by the
temperature selection knob.
Caution!
Static Grill
(Double Grill)
When the “combined grill” is active it
enables grilling with the grill and with the
top heater switched on at the same time.
This function allows a higher temperature
at the top of the cooking area, which
causes more intense browning of the dish
and permits larger portions to be grilled.
Separate oven lighting
By setting the knob to this position the
lighting
inside the oven is switched on,
e.g. use when
washing the oven chamber
.
Caution!
At this oven function knob position.
The oven is not being warmed up.
Ignition without an ignitor
 Light a match.
 Press in the knob to the end and turn
it left to the “large flame” position 
 Ignite gas with a match.
 Set required flame size (e.g.
“economical” )
 Switch off the burner after finishing
cooking, turning the knob right (to the
off position
).
Knob ignition

Press in the knob to the end and turn
it left to the “large flame” position 

Hold until gas is lit

After the flame is lighted release the
pressure on the knob and set a
required flame size.
Large flame
Small flame (“economical flame”)
Burner switched off (gas supply is cut
off)
WRONG
RIGHT
Oven functions and operation
150°
160°
175°
195°215°
235°
255°265°
Oven is equipped with gas valve with
temperature regulator and anti-outflow
protection. To ignite the oven, as in the
description below, keep down the pressed
knob during about 3 s, this is the time
necessary to warm the sensor and to make
the protection f unction. If the flame goes
out, repeat ignition operations after a lapse
of 3 sec. if the flame does not start burning
within 10 sec., repeat the ignition operation
after lapse of about 1 min, i.e. after the
oven ventilation.
Oven