AP PL I A NC ES FO R L I V I N G AFGG54W OPERATION MANUAL
Congratulations, you are now the proud owner of an ARTUSI cooking appliance. Thank you for purchasing ARTUSI and welcome to the ARTUSI Family. This instruction manual has been specially created to inform you of the full range of features your ARTUSI appliance has to offer and serves as an introduction to getting the very best out of your ARTUSI appliance. Dear Artusi Customer, please read this user manual carefully before using the product and, keep it permanently at your disposal.
● The appliance becomes hot during operation. Take care not to touch the hot parts inside the oven. ● ● Please pay attention to children whilst the cooker is in operation, as children do not know the rules of cooker use. In particular, hot surface burners , the oven chamber, grates, the door pane, and pans containing hot liquids standing on the hob may cause burns to children.
HOW TO SAVE ENERGY Using energy in a responsible way not only saves money but also helps the environment. So let’s save energy!nd this is how you can do it: ● Use proper pans for cooking. A saucepan should never be smaller than a burner crown. ● Ensure burners, the grate the hob are clean. Soils can prevent heat transfer-and repeatedly burnt-on spillages can often only be removed by products which cause damage to the environment.
INSTALLATION INSTALLATION The following instructions are addressed to the qualified specialist installing the cooker. These instructions aim at ensuring that installation and maintenance activities are performed as professionally as possible. Ins talling the cooker ● The kitchen should be dry and airy and have effective ventilation according to the existing technical provisions. ● The room should be equipped with a ventilation system that pipes away exhaust fumes created during combustion.
INSTALLATION INSTALLATION Gas cooker is equipped with the gas connection on the right side with exterior thread ISO 7-R1/2. Certain appliance are supplied with the attached liquid gas coupling and the sealing gasket. The connection R1/2 must be gripped tight during the connection p rocedure to prevent it from revolving. Use metal or non metal gaskets for connection packing. Gaskets are intended for single use only.
OPERATION INSTALLATION Burner flame Re-arming from liquid gas to natural gas Re-arming from natural gas to liquid gas Full 1. Exchange a burner nozzle for the appropriate type according to the nozzle table 1. Exchange a burner nozzle for the appropriate type according to the nozzle table. Economical 2. Unscrew an adjusting bolt slightly and adjust the flame size. 2. Screw in an adjusting bolt slightly to the end and check the flame size.
OPERATION OPERATION ● Ignition without an ignitor Light a match. Press in the knob to the end and turn it left to the “large flame” position Ignite gas with a match. Set required flame size (e.g. “economical” ) Switch off the burner after finishing cooking, turning the knob right (to the off position ). Knob ignition Press in the knob to the end and turn it left to the “large flame” position Hold until gas is lit 4.After above operation, oven knob runs normally. Selection of the approprite flame 5.
ELECTEIC GRILL OPERATION To ignite the bottom burner Strike a match, Press down the knob to the stop and turn left to the position corresponding to the temperature chosen, Put the match to the ignition opening (see the figure below) and keep the knob pressed down about 3 sec. from the gas ignition moment . i f the flame has gone out, repeat the ignition operation after lapse of 3 sec.
BAKING IN THE OVEN BAKING IN THE OVEN . Tips for grilling . Grilling is carried out with the oven door . open. . Insert the protective shield under the . control panel. . During grilling the oven thermostat is off,and the grill burner operates at full power. . Grilling tables indicate the recommended temperature,guide levels and quality of meat. Pre-heating of oven for grilling is not necessary. Oil the grill grid before placing the food, otherwise food might stick to the grid.
CLEANING AND MAINTENANCE CLEANING AND MAINTENANCE Door removal In order to obtain easier access to the oven chamber for cleaning, it is possible to remove the door, to do this, tilt the safety catch part of the hinge upwards, close the door lightly, lift and pull it out towards you, in order to fit the door back on to the cooker, do the inverse. When fitting, ensure that the notch of the hinge is correctly placed on the protrusion of the hinge holder.
In the event of an emergency, you should: Switch off all working units of the cooker Disconnect the mains plug Call the service centre Some minor faults can be fixed by referring to the instructions given in the table below. Before calling the customer sup port centre or the service centre check the following points that are presented in the table. PROBLEM Burner flame is not steady. Dew forms at oven door glass during heating up.
Card. Please contact artusi on 1300 694 583 should you not wish to be contacted by Worldwide Appliances. Worldwide Appliances Pty Limited A.B.N. 45868077422 Office: 48-50 Moore Street, Leichhardt N.S.W 2040 Post: Locked Bag 3000, Annandale, N.S.W 2038 P: 1300 694 583 WARRANTY REGISTRATION Your ongoing satisfaction with your artusi product is important to us. We ask that you complete the enclosed Warranty Registration Card and return it to us so that we have a record of the artusi product purchased by you.
5. Proof of Purchase Customers must retain proof of purchase in order to be eligible to make a warranty claim in respect of an artusi product. (c) Worldwide Appliances excludes indirect or consequential loss of any kind (including, without limitation, loss of use of the artusi product) and (other than expressly provided for in these terms and conditions) subject to all terms, conditions and warranties implied by custom, the general law, the Act or other statute.
DISCLAIMER Worldwide Appliances PTY LTD, trading as ARTUSI, is continually seeking ways to improve the design specifications, aesthetics and production techniques of its products. As a result alterations to our products and designs take place continually. Whilst every effort is made to produce information and literature that is up to date, this brochure should not be regarded as an infallible guide to the current specifications, nor does it constitute an offer for the sale of any particular product.
