User Manual

34
EN
Control functions
Before lighting the barbecue:
• Check that all the gas hoses and fittings are tight.
• Open the thin or high cover.
Gas leakage detection test
Never use a match or flame, use soapy water solution and spray or brush the solution onto all
connections. Carefully check for bubbles which indicate a gas leak. If leaks are detected, turn
the gas off and retighten connection(s), then repeat test. The fittings must be thoroughly rinsed
with clean water after testing.
NOTE: The thin cover is intended to protect against the weather. The cover is not intended to
be used as a cooking hood.
• Make sure that all the control knobs are in the closed (O) position.
• Make sure that the cooking surfaces are clean.
• Open the main gas valve.
Ignition instructions
• Do not light the burners with the cooking surfaces covered.
• To light a burner, press the knob and turn it to the “MAX” (fast pre-heating) position.
• Hold it for 5 seconds (count to 10), release it and check the flame from the slots in the front.
• If the burner is not lit, turn the knob to the closed (O) position. Allow the gas to disperse, and
then repeat the ignition procedure.
OFF
MAX
MIN