User Manual

42
Rev.13052022
CLEANING AND CARE
CLEANING OF COOKING PARTS
• Remove from the grill and from the cooking burners all the solid materials and the excess grease using a scraper or a metal
brush with brass bristles
• Use a clean, dry cloth to make sure all surfaces are dry.
OTHER STAINLESS STEEL SURFACES
WARNING
Do not use caustic or abrasive detergents, steel wool or metal scrapers on these stainless steel surfaces because they can scratch
and permanently damage the barbecue.
• Wash all stainless steel parts, including the thin cover, high cover and control knobs, with a soft cloth and warm soapy water
• Clean the surfaces, making sure to rub/dry in the direction of the grain in order not to damage the stainless steel.
• The inside of the barbecue can be cleaned with a soft cloth soaked in warm soapy water. The front panel/tray placed inside can
be removed for an easy cleaning.
• Use a clean, dry cloth to make sure all surfaces are dry.
• VERY IMPORTANT! After drying, nish off the process with 3M™ Stainless Steel Cleaner and Polish or similar product in order
to protect the stainless steel surface from corrosion and give it a polished shine.
CLEANING THE COOKING GRILLS MADE OF CAST IRON
• Clean with an adequate brass bristle brush. If necessary, remove from barbecue, wash with warm soapy water, rinse with water
and dry carefully.
VERY IMPORTANT! After drying, nish off the process with 3M Stainless Steel Cleaner and polish or similar product in order to
protect the stainless steel surface from corrosion and give it a polished shine.
IMPORTANT: After cooking and cleaning, the cast-iron grids should be oiled. After drying, nish off the process with 3M
Stainless Steel Cleaner and polish or brush. Afterwards, use a cloth to rub the cookware as if you want clean the oil you
just placed on it.
WARNING
Pay particular attention (especially when cleaning the knobs and around the knobs) to avoid water and soap residue from entering
the control panel containing the valves or in the burners. Also, be careful not to touch the ignition electrode and thermocouple.
There must be 3 mm of space between the electrode and the burners (see drawing on the next page). If the unit is exposed to the
elements we recommend you use the optional vinyl cover.
3 mm
3 mm