User Manual

22
Rev.13052022
• When converted for the use of universal LPG, the appliance is designed to use different types of cylinders depending on the
installation made. See the chapters on Installation Preparation and Connection of the cylinder.
• The gas cylinder must be manufactured and marked in accordance with the specications for LPG cylinders.
• The shut-off valve must be closed when the appliance is not in use.
• The gas cylinders must be kept in an approved housing out of the reach of children.
• When you disconnect the gas cylinder, make sure all the control valves are in the “OFF” (O) position.
• Before disconnecting, remove the cylinder from any housing in which it may be located.
• When you reconnect the hose to the cylinder, make sure all the connections are tight before placing it back in its
compartment.
• After each connection of a cylinder, perform a leak test as described below.
LEAK TESTING PROCEDURE
• Make sure that all the gas taps are in the “OFF” (O) position.
• Mix a solution of water and detergent or soap in a small container.
• After connecting the hose, open the valve on the gas cylinder or gas system tap.
• Using a brush, paint the solution on the gas connection points and check for bubbles.
• Bubbles indicate a leak.
• Close the valve and tighten the tting, possibly inserting a new gasket. Repeat the leak test.
• If the leak persists, turn off the gas and contact an authorized gas system maintenance technician to repair the leak.
GAS CYLINDER SAFETY INFORMATION (OUTDOOR USE ONLY)