User Manual

Arturia Microbrute User’s Manual 50
7 Legal Notes
No liability for consequential damages
Neither ARTURIA nor anyone else involved in the creation, production, or delivery of this
product shall be liable for any direct, indirect, consequential, or incidental damages
arising out of the use of, or inability to use this product (including without limitation,
damages for loss of business profits, business interruption, loss of business information and
the like) even if ARTURIA was previously advised of the possibility of such damages.
Some states do not allow limitations on the length of an implied warranty or the
exclusion or limitation of incidental or consequential damages, so the above limitation
or exclusions may not apply to you. This warranty gives you specific legal rights, and you
may also have other rights which vary from state to state.
FCC Information (USA)
DO NOT MODIFY THE UNIT! This product, when installed as indicated in the instructions
contained in this manual, meets FCC requirements. Modifications not expressly
approved by ARTURIA may void your authority, granted by the FCC, to use the product.
IMPORTANT: When connecting this product to accessories and/or another product, use
only high quality shielded cables. Cable (s) supplied with this product MUST be used.
Follow all installation instructions. Failure to follow instructions could void your FFC
authorization to use this product in the USA.
NOTE: This product has been tested and found to comply with the limit for a Class B
Digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide
a reasonable protection against harmful interference in a residential environment. This
equipment generates, uses and radiates radio frequency energy and, if not installed
and used according to the instructions found in the users manual, may cause
interferences harmful to the operation to other electronic devices. Compliance with
FCC regulations does not guarantee that interferences will not occur in all the
installations. If this product is found to be the source of interferences, which can be
determined by turning the unit “OFF” and “ON”, please try to eliminate the problem by
using one of the following measures:
• Relocate either this product or the device that is affected by the interference.
• Use power outlets that are on a different branch (circuit breaker or fuse) circuits or
install AC line filter(s).
• In the case of radio or TV interferences, relocate/ reorient the antenna. If the antenna
lead-in is 300 ohm ribbon lead, change the lead-in to coaxial cable.